Batching plant SCADA that weighs every batch right.
DRS software and Phoenix Contact PLC panels for concrete batching and pumping. One team builds, calibrates and supports the whole system.
DRS SCADA software
Three editions, from small RMCs to full-scale plants with reporting.
PLC panels
Built on the Phoenix Contact ILC 131 ETH and wired by our own team.
Calibrated to set point
Every material is calibrated so each weighment lands on its set point.
Remote support
Software issues solved over a remote session; hardware faults get a site visit.
DO IT RIGHT.
11+ years automating batching plants
Three DRS editions, sized to your plant.
Each edition includes everything in the one before it, so a plant can start on Micro and move up without retraining operators.
DRS-Micro
Small RMCs and project sites
- SCADA control and recipe storage
- Batch and production reports
- Customer and vehicle log
DRS-Ultra
Mid- to large-scale plants
- Jog, in-flight and deadweight correction
- Pump and TM modes, mixer gate sensor
- Cycle charts and consumption reports
DRS-Ultra+
Full-scale plants with reporting
- GST-compliant invoices and auto print
- Reports by SMS, email and Telegram
- SAP integration and 24/7 support
The DRS-Ultra V6 screen your operators work on.
Built after studying how operators actually work: every bin, silo, weigher and timer on one screen, and settings a supervisor can change in seconds.
- In-flight correction in normal, software intelligent or fully artificial mode
- Deadweight per material, set by hand or automatically
- Calibration for aggregate, cement, water, admix and ice flakes
Every plant’s output, live at head office.
Two web portals read straight from DRS at each plant: production, materials and dispatch, without phone calls or end-of-day spreadsheets.
DRS Live Monitor
Production, material consumption and delivery challans across all your DRS ready-mix plants, updating as batches finish.
DRS Matrix Flow
Multi-plant dashboards for daily production, mix design, fleet and consumption, with role-based access.
PLC panels built on the Phoenix Contact ILC 131 ETH.
We design, build and wire the control panel and operator desk, then commission the plant with DRS software so hardware and software work as one.
- Panel design, build and site wiring
- Operator desks with indicators and controls
- Calibration, commissioning and trial batches
- Old panels rebuilt and upgraded
One team from site study to remote support.
The people who build your panel and install your software are the people who answer when you call.
- 01
Study the plant
Plant type, capacity and materials, and a list of what the control system has to do.
- 02
Build and install
We build the PLC panel and install it with DRS software at your site.
- 03
Calibrate
Every material is calibrated so each weighment lands on its set point.
- 04
Commission
We run the plant end to end until it batches to specification.
- 05
Train your team
Operators learn the software and the daily routine on their own plant.
- 06
Support
Software issues are solved over a remote session; hardware faults get a site visit.
Plants and panels we have automated.
Photos from plants running DRS: ready-mix producers, contractors’ project sites and the panels behind them.
Trusted by ready-mix companies and plant builders.
Contractors, ready-mix producers and plant manufacturers run their batching on DRS software and panels.
Awarded to Do It Right Solutions by Goodwill Automations, Chennai.
Ready-mix producers, contractors and plant builders run DRS
Let’s make your plant run right.
Planning a new plant, or upgrading an old panel? Tell us your plant type and capacity, and we’ll reply on WhatsApp or call you back.
- Call+91 9563 863 333
- Emailsales@doitrightsolutions.in
- OfficeGNT Road, Karanodai, Chennai